Silicon Labs BRD427xA Rev A05
Jump to navigation
Jump to search
This article describes specifics for the Silicon Labs BRD4277A and BRD4278A Rev A05 evaluation boards.
Preparing for J-Link
Connect the board to a suitable motherboard (e.g. the Silicon Labs BRD4001A), and then connect the J-Link to the motherboard's debug port.
Verify the connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Silicon Labs BRD427xA Rev A05. It is a simple Hello World sample linked into the internal flash.
Setup
- Embedded Studio: V8.22a
- Hardware: Silicon Labs BRD427xA Rev A05
- Download example project