NXP X-OM2CTN730

From SEGGER Knowledge Base [STAGING]
Jump to navigation Jump to search

This article describes specifics for the NXP X-OM2CTN730 evaluation board.

Preparing for J-Link

  • Connect the J-Link to J302
  • Power the board via J400.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP X-OM2CTN730.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://kb.segger.com.staging.segger-sys.de/index.php?title=NXP_X-OM2CTN730&oldid=31739"