Infineon PSoC C3 Control Card

From SEGGER Knowledge Base [STAGING]
Jump to navigation Jump to search

This article describes specifics for the Infineon PSoC C3 Control Card evaluation board.

Preparing for J-Link

  • The board has a J-Link OB. Simply connect the board through the USB-C connector.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Infineon PSoC C3 Control Card .
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://kb.segger.com.staging.segger-sys.de/index.php?title=Infineon_PSoC_C3_Control_Card&oldid=31562"